Rangemaster RC60SS Betriebsanweisung Seite 12

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 20
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 11
10
INSTALLATION
Check the appliance is electrically safe when you have finished.
Dear Installer
Before you start your installation, please complete the details
BELOW.
Should your customer have a problem relating to your
installation they will be able to contact you easily.
Safety Requirements
The hob must be installed in a well ventilated space, in
accordance with the section entitled ‘Electrical Connection’.
Read these instructions before installing or using the
appliance.
Provision of Ventilation
All rooms require a window that can be opened, or
equivalent, while some rooms require a permanent vent in
addition to the window.
Location of the Hob
The hob may be installed in a kitchen/kitchen diner but NOT
in a room containing a bath or shower.
This appliance is designed for domestic cooking only. Use for
any other purpose could invalidate any warranty or liability
claim.
This appliance should not be installed in a boat or
caravan.
The hob must be installed in accordance with the relevant
Building regulations and IEE regulations.
You will need the following equipment to complete the hob
installation satisfactorily:
Multimeter (for electrical tests)
You will also need the following tools:
1. Electric drill
2. Jigsaw
3. Steel tape measure
4. Cross head screwdriver
5. Pencil
6. Sharp knife
Checking the parts
Ceramic hob
Fixing brackets and screws (4 off )
Seal
Check that the appliance is in a good condition after
having removed the packaging. In case of doubt, do not
use the appliance and contact the retailer.
Never leave the packaging materials (cardboard,
plastic bags, polystyrene foam, etc.) within children’s
reach since they could become potential sources of
danger.
Positioning the Hob
The hob should be fitted into a work surface, which is at least
600mm deep. In position, it has a maximum thickness of 5mm
from the top of the work surface. The cut-out dimensions are
shown in (Fig.5-1) and the minimum clearances in
(Fig.5-2). The minimum recommended distances from the
hob to nearby surfaces are shown in (Fig.5-3).
*Any hob hood should be installed in accordance with the
hood manufacturers instructions.
Surfaces of furniture and walls at the sides and rear of the hob
should be heat, splash and steam resistant. Certain types of
vinyl or laminate kitchen furniture are particularly prone to
heat damage and discolouration.
We cannot accept responsibility for damage caused by
normal use of the hob to any material that de-laminates
or discolours at temperatures less than 65°C above room
temperature.
For safety reasons curtains must not be fitted immediately
behind the hob.
5. Installation
DocNo.062-0001 - Installation - RC60 hob
Seitenansicht 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare